Metal Die-Cut Care
Handling & Safety
- Please handle your metal die-cuts with care. Some edges may be sharp.
- When separating die-cuts, do so carefully. Use pliers to remove the small connector pieces, as they can be sharp and may cause injury.
- Die-cuts are sharp — handle with caution.
- Not a toy. May pose a choking hazard. Keep away from children.
- Do not leave die-cuts on the floor to avoid accidents or damage.
Usage Instructions
- Metal die-cuts are designed to cut thin cardstock (65 lb or lighter).
- They are not suitable for:
- Thick cardstock
- Coated cardstock
- Chunky glitter cardstock
- For best results:
- Run metallic or glitter cardstock (65 lb) through the machine twice for a clean, crisp cut
- Cut one sheet at a time
- For intricate designs, run the die through the machine twice
Machine Tips
- Always use the correct plate “sandwich” recommended by your die-cut machine
- For deeper pressure, you can add an extra sheet or two of cardstock between the plates if needed
Storage
- Store die-cuts on a flat, dry surface to prevent warping or damage