When you receive your diecuts. Please be careful when handling them. Some edges can be sharp. Also, when you take your diecuts apart, please do it carefully and make sure to use some pliers to cut out the little pieces that hold the diecuts together as they are small and can be sharp stabbers.
Metal diecuts are intended to cut thinner cardstock of 65 lbs or lighter. It will not cut thicker coated cardstock or the chunky glitter cardstock. If you find 65lb metalic and glitter cardstock, make sure to run it through the machine twice to get a perfect crisp cut. Only cut one sheet at a time with these diecuts. For more intricate cuts, run it through the machine twice as well.
Please store your diecuts in a dry and flat surface. Make sure that you are using the proper amount of layers as instructed by you diecut machine. You can always layer up for a more deep pressure with a sheet or two of cardstock in between the plates.
Diecuts are sharp handle with caution
Diecuts are not a "toy"
Dont leave diecuts on the floor.